The Best Place To Buy Sound Equipment, Lamps, Stages, Dance Floors
DescriptionPA System ideal for marquee weddings and background music.
4x Soundlab 100w 10" Speakers
With 4 speakers it's more than loud enough to fill a room with background music or amplify the best man's speech.
Gemini X-04 Power Amp
Bi-polar output stage technology for sound quality and reliability
High output power to drive professional loudspeakers without clipping
Comprehensive protection circuitry
Three modes of operation - stereo, parallel mono and mono bridge
Ground lift switch for flexibility in installations
Large VU-meters & Clip LEDs for better control
Efficient dual aluminum extrusion heatsink design with directly mounted output transistors for no-fault operation
Air guide with front-to-rear airflow for thermal stability and reliability
Compact 3U well balanced enclosure Steel reinforced chassis construction for durability and longevity
1/4 TRS & XLR balanced/unbalanced input connectors
Both Channels Driven - @ 8 Ohms = 200 Watts,
@ 4 Ohms = 300 Watts Mono Bridge -
@ 8 Ohms = 600 Watts Dynamic Headroom -
@ 8 Ohms = 1.6 dB, @ 4 Ohms = 2.2 dB
Frequency Response - 30 Hz - 50 kHz Total
Harmonic Distortion - Less Than 0.05%, Typical 0.02% @ 1 kHz
Signal to Noise Ratio - 100 dB Below
Rated Power @ 8 Ohms
Damping Factor - Greater Than 200 @ 8 Ohms
Slew Rate - 20 V/ S
Voltage Gain - 32 dB
Input Sensitivity (Rated Power @ 8 Ohms) -
1 Vrms Input Impedance (Unbalanced) -
10 kOhms Input Impedance (Balanced) -
Power Consumption (Rated Power @ 4 Ohms, Both Channels Driven) - 1200 VA AC
Power Requirements - 110-120/220-240 Volts, 60/50 Hz.
Indicators - 1VU Meter per Channel, 1 Power LED, 1 Clip LED
Cooling - Fan, Front-to-Rear Forced Air
Protection - Short Circuit, DC,
Thermal Cut-off, Sub/Ultrasonic Frequency Filters,
Secondary DC Fuses
Kam DVD drive
Ideal for background music
Stanton SMX 201 Mixer
2 line and 2 phono inputs. 2-band EQ and gain control on each channel. Cue section featuring level and pan. Mic input with 2-band EQ. User-replaceable faders.
2 line and 2 phone inputs
2-band EQ and gain control on each channel
Cue section featuring level and pan
Mic input also with 2-band EQ
Faders are user replaceable
RCA phono inputs
RCA master output
1/4" headphone input
Kam KWM 1940 pair of wireless microphones and receiver
The KWM1940 is a portable dual UHF wireless mic kit.
It is a 16 channel PLL preset system with a DIP switch channel selection
RF SAW frequency filtering
individual signal status LEDs
high sensitivity circuit design.
It also features
Integral preset compressor / limiter system
Individual balanced XLR audio outputs
Unbalanced jack 'mix' audio output
Individual volume controls
easy grip microphone coating
Mic on/off standby switch
Transmitter battery statues LED
AA batteries 6 hour life.
The KWM1940 has a range of 50m
Frequency response of 40Hz-15kHz +/-3dB, a S/N ratio of >90dB and 16 frequencies between 863MHz - 865MHz. Belt pack available.
It requires no additional end user license.
For the MC
Loads of cables, stands, etc
This is a well looked after complete PA system.
Normally this would hire out at a £100 per event. So will repay itself very quickly.
Easy to set up - takes about 15 mins.
Click to see all items from this seller
Delivery notesCollection from Suffolk
Or could arrange delivery at your cost.
This item is now sold